![]() ![]() Within iCue, though, that speed should be labelled properly as the Pump Speed. Although the CPU_FAN header may label the speed signal it can access as the "CPU Fan" speed, that really is the PUMP speed of the AIO system. ![]() ![]() The ONLY place that can access the speeds of the rad fans is the iCue software tool, and it may only display one fan's speed. Since the rad FANS in this system are powered and controlled through the pump and the USB2 cable connection that iCue uses for communication, the speed of those fans is NOT available to the mobo fan headers at all. The iCue software also will monitor for failure. This has two functions: it gets the pump speed into the mobo where the Corsair iCue software can access it, AND then that signal also is monitored by the mobo's own tools for possible FAILURE (zero speed) of the pump. That 3-pin female connector on the end of a single wire from the PUMP component is solely to send the PUMP speed signal to the CPU_FAN header. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |